User guide

33
APEX VIEWPOINT SYSTEM
To create a custom scan pattern:
1
In the Advanced Menus screen, press the
RIGHT ARROW key to move the highlight to the
Setup menu.
2 Use the DOWN ARROW key to move the
highlight to Scan and press ENTER; the Pattern
Setup
screen appears with the first port position
or computer name highlighted.
In the Scan Pattern Setup screen shown, the
order-by-port mode is selected. Your screen
may appear different. See Changing Menu
Attributes found later in this chapter.
3 Use the DOWN ARROW key to select the port
number of the first computer to be included in
the scan
—or—
if your computers are listed by name, select the
name of the first computer to be included in the
scan.
4 Press the RIGHT ARROW key to highlight the
Sec column, and then type the number of
seconds (255 is maximum) that you want this
computer to be selected before switching to the
next computer in the sequence.
5 Press the DOWN ARROW key to move the
highlight to the next computer you want to
include in the scan and repeat steps 3 and 4.
6 Press ENTER to start the scan sequence.
OSCAR ADVANCED MENUS
COMMANDS SETUP
Scan
OSCAR
Flag
Security
SCAN PATTERN SETUP
Port Sec Name
1 15 COMPUTER 1
2 15 COMPUTER 2
3 15 COMPUTER 3
4 15 COMPUTER 4
5 15 COMPUTER 5
6 15 COMPUTER 6
7 15 COMPUTER 7
F2 for defaults
Scanning the Computers