Owner`s manual

BOATING SAFETY
1-15
Drainage System
Bilge Pump: Your Skeeter boat is equipped with a
drainage system that channels water entering the
boat from the storage compartments to the bilge
under the engine compartment. When the pump is
on, most of the water in the bilge will drain through
the outlet. For manual bilge pump systems, the pump
will operate when the bilge pump switch is turned on.
If your boat is equipped with an automatic bilge
pump, the pump will sense when there is excessive
water in the bilge and will automatically turn on.
On boats equipped with an automatic bilge system,
the bilge switch can be used to override the
automatic system and to test the bilge pump. When
the switch is activated, listen to hear if the pump is
operating. It may not pump water unless water is
present. Do not operate the bilge pump continuously
when it is dry.
Inspect the bilge area frequently for evidence of
excessive water. Continuous operation of the bilge
pump can indicate excessive water entering the
bilge. Debris can also prevent the pump from
operating or make it operate continuously. Test the
bilge pump at regular intervals. Make sure no debris
is blocking the bilge pump float.
Drain Plug: A drain plug is located at the center of
the stern to allow more complete draining when the
boat is removed from the water.
Table of Contents