Owner`s manual

3-28
Fuel
The FUEL button allows the port or starboard fuel tank
level to be indicated on the fuel tank level gauge. The
port fuel tank is the default tank upon initial power up.
An LED is used to indicate which fuel tank is being
indicated by the fuel tank level gauge. Push the FUEL
button to switch fuel tank indicators.
Port Fill / Starboard Fill
The PORT and STBD FILL buttons control power
ON/OFF to the corresponding livewell fill water pump.
Pressing the button once activates the manual mode
(constant on) of the livewell water fill pump. Pressing
the button again (twice) activates the automatic mode,
allowing the aerator timer button to control the livewell
fill water pump on/off rate. Pressing the button a third
time turns off the livewell fill water pump.
Port Recirculation / Starboard Recirculation
The PORT and STBD RECIRC buttons control power
ON/OFF to the corresponding livewell recirculation
water pumps. Pressing the button once activates
manual mode (constant on) of the livewell recirculation
pump. Pressing the button again (twice) activates the
automatic mode, allowing the aerator timer button to
control the livewell recirculation water pump on/off
rate. Pressing the button a third time turns off the
livewell recirculation water pump.
Aerator Timer
The AERATOR TIMER button is active only when one
of the following buttons are in automatic mode: PORT
or STBD FILL, PORT or STBD RECIRC. When any of
these buttons are switched to automatic mode, the
aerator timer button defaults to low mode (1 minute on,
7 minutes off). Pressing the button once turns on the
medium mode (1 minute on, 3 minutes off). Pressing
the button again (twice) switches the aerator into high
mode (1 minute on, 1 minute off). Pressing the button
a third time switches the aerator back to low mode.
Table of Contents