User guide

Chapter 3: Basic Operations 25
To remove a server from the scan list:
1. In the Scan Pattern Setup screen, type the port number of the computer to
be removed.
—or—
If your servers are listed by name, type the rst few letters of the name of
the server.
2. Highlight the Sec column and type Ø for the number of seconds.
3. Press Delete while in the Scan Pattern Setup screen to delete the
highlighted computer and all entries below it.
4. Press Enter to save the settings and exit the menu. The new scan pattern
replaces the standard or previous custom scan pattern.
To set up a custom scan pattern:
1. In the Scan Pattern Setup screen, type the port number of the rst server to be
included in the scan.
— or—
If your computers are listed by name, type the rst few letters of the name
of the rst server to be included in the scan.
2. Highlight the Sec column, and then type the number of seconds you want this
computer to be selected before switching to the next server in the sequence.
3. Repeat steps 1 and 2 for each of the remaining servers and press Enter. The
new scan pattern replaces the standard or previous custom scan pattern.
To start the scan mode:
Highlight Commands - Scan in the Advanced Menus screen and press Enter.
To cancel scan mode:
Press any key (except Print Screen) or move the mouse; the scan stops at the
currently selected computer.
Controlling the Status Flag
The status flag displays the name or port number of the currently selected
server. You can choose to display the status flag at all times, for a few seconds
after switching or not at all. You can also change the color of the status flag
and its location on the screen.