User's Guide

GPS Installation

Connect the GPS antenna cable (indoor use only) to the GPS port of the eFemto.

Note: The GPS antenna must stay connected to the eFemto at all times for

operation. The initial GPS fix can take up to 60 minutes.

Ethernet and Power Connections

Attach the supplied Ethernet cable from your router or modem LAN port to the

eFemto WAN/PoE port for network connectivity.

Plug in the Power Supply and insert the power cable into the eFemto Power port.

Automatic startup and hardware initialization will begin.

POWER ON

At startup, the eFemto will conduct self configuration. This will take between

30 - 60 minutes the first time the eFemto turns on.

Optional Accessories Available

 Power over Ethernet (POE) Device

A full list of optional accessories can be viewed and ordered from

www.verizonwireless.com.

Automated Startup

The following Status LED sequence will occur. Upon successful setup, the LED will

blink green.

Note: If the LED fails to turn green after one hour or is blinking a series of red

pulses, consult the troubleshooting section (below).

Troubleshooting

No GPS Signal

The Sync LED off and Alarm LED fix red indicates no GPS signal. Check the About

eFemto page in the Advanced Settings web interface, on the tabs for “Status and

Alerts” or “GPS” to see the status of the GPS constellation.

Is my wireless device connected to the eFemto?

Using the Advanced Settings web interface, sign in and the Connected Devices

panel for indication of connected users.

Cannot reach eFemto GUI or locked out of device.

Press the RESET button for 10 seconds to reset the system to factory default

settings.

4G/5G Network Extender 4

for Enterprise

Installation Reference Guide

Doc-3220 Rev 4.0