Instructions / Assembly
Page 3Rev. 110619
DiscountRamps.com • 1-888-651-3431
Step 2. Install the ramp bracket (E) to the front corner of the carrier basket using one eye bolt (F), the
round head bolt (I), and M10 lock nuts (P). It may be necessary to extend the ramp in order to install
the hardware. (See Extending the Ramp section below.) Install the eye bolt in the top hole, with the
nut on the inside. Tighten with a 17mm wrench. Install the round head bolt in the bottom hole, with the
nut on the outside. Tighten with a 6mm hex key and 17mm wrench.
Step 3. Install the second eye bolt (F) on the back corner of the carrier basket using the M10 washer
(O) and lock nut (P).
Assembly
Step 1. Place the basket assembly (A) upside down, then secure
the main support tube (B) in place using the M10 carriage bolts (H),
U-brackets (D), and lock nuts (P). Make sure the extended part of the
support tube is towards the back (opposite side of reectors). Tighten
securely with a 17mm wrench.
(1a)
(2-3)
(2a) (2b) (3)
(1b)
(1c)