Instructions / Assembly

Page 4Rev. 062118

DiscountRamps.com • 1-888-651-3431

Clamp Arm Assembly and Attachment

Clamp arms may need to be attached to the clamp assembly

base (G).

Step 1. Disassemble each arm by unscrewing the turn knob

(CA6) at the end of the arm. Carefully remove the parts by sliding

them o󰀨 the connector rod (CA7).

Step 2. Place the bracket (CA2) onto the clamp assembly base

(G).

Step 3. Fit the metal plate (CA1) onto the bracket (CA2).

Step 4. Slide the connector rod (CA7) through the bracket (CA2)

and metal plate (CA1) assembly.

Step 5. Fit the main tube (CA8) onto the connector rod (CA7).

Step 6. Slide the clamp (CA5) and spring (CA4) onto the connec-

tor rod (CA7). Slide one end of the clamp on rst, then the spring,

then the other end of the clamp so that the spring ts into the

middle part of the clamp.

Step 7. Slide the rubber stopper (CA3) onto the connector rod

(CA7).

Step 8. Screw the turn knob (CA6) onto the end of the connector

rod (CA7).

CA2

CA7

CA5

CA4

CA3

CA6

CA8

CA1