AFFORDABLE ADJUSTABLE DESKS FOR EVERYONE Little Soleil DX Children’s Adjustable Desk Assembly Guide REV-1609A
Table of Contents CAUTION, USE& LIABILITY.....................................................................................................................................3 PARTS & COMPONENTS LIST...................................................................................................................................4 ASSEMBLY INSTRUCTIONS......................................................................................................................................5 CARE INSTRUCTIONS.....
CAUTION, USE& LIABILITY CAUTION Keeps small items away from small children. Keep hands off pinch points. Do not sit or stand on the desk. Do not crawl or lie under the desk. USE & LIABILITY This children’s adjustable desk is designed for use in an indoor environment and dry work area only .The desk height is adjustable so that it can be positioned at the most suitable height for your growing child. Any other use is at user’s risk .
PARTS & COMPONENTS LIST No.
ASSEMBLY INSTRUCTIONS BEFORE YOU BEGIN Lay out all components and hardware to ensure that you have all the parts listed on the parts page. Contact manufacturer on Page 11 for missing parts and components. Assemble on soft and non-abrasive surface to avoid scratch or damage to the top. There are two types of screws needed for assembly – A and B. Only Step 4 requires Screw A. Use Screw B for all other steps. STEP 1 Secure legs to the desk top.
STEP 2 Crank can be installed on either side. Take note of the spindle’s both ends. One end has hexagon rod and the other end has tube with a small opening. Insert hexagon end to the side that crank will NOT be installed. STEP 3 Thread crank thru the leg and into the “tube” end of spindle. There is one mounting holes on the crank. Make sure that you can see the hole thru the opening of tube.
STEP 4 Use Screw A to secure crank to the spindle. Half-tighten the crank and make sure it turns freely before tightening the screws fully. Slide the crank to the left or right to make adjustment if needed. STEP 5 Secure crossbar with Screw B, two on each side.
STEP 6 Follow pre-drilled holes and assemble the drawer. STEP 7 Follow pre-drilled holes and secure drawer to the back of the top.
STEP 8 Follow pre-drilled holes to secure shelf to the holders STEP 9 Clamp the shelf onto the rear edge of the desk.
STEP 10 Adjust leveling studs if needed. CARE INSTRUCTIONS Recommend checking the screws and bolts several times a year to ensure they stay tight. Desk is intended for use in dry, indoor areas. Avoid extended exposure to direct sunlight. For all surfaces: wipe clean with a damp cloth and a weak cleaning solution, and then dry with a clean and dry cloth.
WARRANTY INFORMATION SCOPE OF WARRANTY Apex Furniture LLC(“ApexDesk”) warrants to the original purchaser its new desk (except for components not warranted under “Exclusions”) manufactured by Apexdesk to be free from defects from material and workmanship under normal use and service.
