User guide

About Local Administrative Procedures
Issue 4 February 2010 31
Note:
Note: Unless otherwise prohibited using administration, the user can view but not
change most of the parameters associated with Local Administrative Procedures.
For more information about this option, see the applicable user guide(s).
Local Programming Option Code See
Set 802.1X operational mode 8 0 2 1 X (8 0 2 1 9) Set the 802.1X Operational
Mode on page 32.
Static addressing A D D R (2 3 3 7) Static Addressing Installation on
page 35.
Automatic Gain Control A G C (2 4 2) Disable/Enable Automatic Gain
Control on page 38.
DHCP chaddr field value C H A D D R (2 4 2 3 3 7) Manually Setting the DHCP
Client Hardware Address on
page 40.
Clear values to factory defaults C L E A R (2 5 3 2 7) Clear Procedure on page 41
.
Enable/disable Debug Mode D E B U G (3 3 2 8 4) Disable/Enable Debug Mode on
page 42.
Group Identifier G R O U P (4 7 6 8 7) Group Identifier on page 43
.
Interface Control I N T (4 6 8) Interface Control on page 44.
Event Logging L O G (5 6 4) Disable/Enable Event
Logging on page 46.
Reset the telephone R E S E T (7 3 7 3 8) Reset System Values on
page 48.
Restart the telephone R E S E T (7 3 7 3 8) Restart the Telephone on
page 49.
Signaling protocol identifier
(not applicable to Release 1.0)
S I G (7 4 4) Signaling Protocol Identifier on
page 50.
Site-Specific Option number S S O N (7 7 6 6) Site-Specific Option Number
Setting on page 51.
Test the telephone T E S T (8 3 7 8) Self-Test Procedure on page 52.
View current parameter values
and file names
V I E W (8 4 3 9) The View Administrative
Option on page 60.