AWID RFID Module Installation Manual Series 500 Reader Installation Version 1.00 Last Revision: 11/5/2009 Copyright 2009 API Healthcare Corporation.
Purpose This document describes the installation process of the AWID RFID Module in the Series 500 Reader. This module is an option that may be purchased by the customer. Model Number: RDR-69N1AKU-API Part number: EIPCR6010 NOTICE: Installation of this module may only be made by qualified API Healthcare employees. This is not a field upgrade, and must be done at the API factory. FCC Notice FCC ID: W7N-PROXAW01 Compliance Statement (Part 15.19) This device complies with Part 15 of the FCC Rules.
Installing the RFID Module 1. Place double sided foam tape on the back side of the module as shown in Figure 1 Figure 1. 2. Place the module tape side up as shown in Figure 2. Figure 2. Last Revision: 11/5/2009 Copyright 2009 API Healthcare Corporation.
3. Place the TA-500 main circuit board in the case in the normal manner. Press down the TA-500 board to ensure it makes contact with the tape on the RF module. 4. Install the screws to mount the main board to the case. Figure 3. 5. Connect the cable from the RFID module to the COM2 connector as shown in Figure 3. 6. Complete final assembly of the unit. Testing the RFID Module 1. Apply power and wait for the unit to boot up. 2. Enter Diagnostic Mode: a.
