User manual

ARCHMI-7XX User Manual

Multiple Monitors

Multiple Monitors support from two to six touch screen displays for one system. The PenMount drivers

for Windows 2000/WIN 7 support Multiple Monitors. This function supports from two to six touch

screen displays for one system. Each monitor requires its own PenMount touch screen control board,

either installed inside the display or in a central unit. The PenMount control boards must be connected

to the computer COM ports via the RS-232 interface. Driver installation procedures are the same as

for a single monitor. Multiple Monitors support the following modes:

Windows Extends Monitor Function

Matrox DualHead Multi-Screen Function

nVidia nView Function

NOTE: The Multiple Monitor function is for use with multiple displays only. Do not use this function if

you have only one touch screen display. Please note once you turn on this function the rotating

function is disabled.

Enable the multiple display function as follows:

1. Check the Enable Multiple Monitor Support box; then click Map Touch Screens to assign touch

controllers to displays.