Owner`s manual

CAUTION - USE CARE - DO
NOT allow any object to touch the ribbons!!
(3) Unpack outer midrange tweeter-left, MRT-L, and MRT-R and place
the outer boxes in position
A
and B as shown in
FIG.
1. During
the removal of the inner containers do not rotate the container
(lift straight out). The inner containers for MRT-L and MRT-R
should be placed on the floor as shown in
FIG.
1, position
G
and
H. Please note the top and bottom orientations of the
containers.
The rear bottom of MRT inner box should be up.
The outer MRT boxes will be used as a work surface for the
assembly
of the speakers. Clean boxes to prevent soiling the speaker
grill and suede.
(4) a) Turn right woofer, W-R, outer box upside down.
b) Cut strapping and remove outer box.
c) Turn inner box so that rear bottom printing is in up position
and toward right speaker position.
CAUTION -Keep fingers away from ribbon.
d) Lift W-R by holding at top and bottom and place on boxes
A
and
B as shown in
FIG. 2.
e) Remove the white foam end caps.
f) Carefully cut tape holding inner box together.
g) Remove top and bottom corrugation piece and place in outer
woofer box.
h) Please note the bottom of the woofer is toward the right speaker
position with the ribbon down and cable visible.
i) Loosen the screws nearest to the MRT to make the MRT/woofer
assembly easier.
(Page 2)