User`s guide

APOGEE ELECTRONICS
16
Ensemble – User’s Guide
Maestro 2
Routing
The input and output routing control is accomplished across a combination of routing grids. With this release of Mae-
stro 2 software, it is now possible to route individual stereo pairs from hardware inputs directly to hardware outputs
while also routing other pairs through a DAW or other software.
Audio Routing is accomplished using the following three routing grids:
Standalone Routing - Route Ensemble hardware inputs to hardware outputs.
Input Routing - Route Ensemble hardware inputs to Mac audio software inputs.
Output Routing - Route Mac audio software outputs to Ensemble hardware outputs.
When using these routing grids, hardware outputs may only have one source, either a hardware input or a software
output. Thus, once a hardware output is assigned in either the Standalone or Output Routing grid, it is removed from
the other grid. Each pair of Ensemble hardware outputs may be freely routed in either the Standalone or Output Rout-
ing grid.
To route a mix of hardware inputs and software outputs to a hardware output, use Ensemble’s low latency mixer in
the Mixer tab window.