User`s guide

APOGEE ELECTRONICS
Ensemble – User’s Guide
27
Maestro 2
Step by Step instructions to record with the low latency mixer
In the Mixer tab window, set the Software Return drop down menu, on both Mixer 1 and Mixer 2 (if desired),
to Analog 1-2. Set both the Software Return and Mixer Master faders to 0dB.
Play the session in your DAW. You should hear playback in headphones connected to Ensemble’s HP 1
and HP 2 outputs.
Ensure the desired tracks are in “record ready” in your DAW.
Connect the signal(s) to be recorded to Ensemble’s hardware inputs - the signal levels will appear on the
Maestro Mixers’ meters.
Raise the faders to create a suitable monitor mix of the input and playback signals.
Record!
In this example, both Mixer 1 and 2 are in use, but under many circumstances only one mixer is necessary.
If you would like to hear the same mix in both Headphone outputs, just assign both Headphone sources to
Analog 1-2 in the Output Routing Tab.