User`s guide

APOGEE ELECTRONICS
Ensemble – User’s Guide
25
Troubleshooting
I want to run Ensemble at 176.4 –192 kHz, but I only see 44.1–96 kHz in AMS.
– Ensemble can operate at sample rates of 44.1 to 96 kHz or 176.4 to 192 kHz, as determined by
the Sample Rate Range setting in the Apogee Maestro Settings panel. To change the sample rate
range, open the Maestro>Window>Settings panel and set Sample Rate Range to the desired
setting. When setting the range, quit all audio software apps and allow 30 seconds for Ensemble to
reboot at the new sample rate range
I’m trying to lock Ensemble to an external source, but the STATUS LED just won’t stop
blinking.
– When Ensemble is locked to an external source, Ensemble’s sample rate is still determined by
the selection in software. Thus, the sample rate of the external source must be manually set to
match the software sample rate. For example, if you want to open a session at 88.2 kHz but lock
Ensemble to word clock from an Apogee Big Ben, you must manually set the Big Ben to 88.2 kHz.
How do I reset Ensemble to its default settings?
– Ensemble may be reset by pressing in the front panel left encoder and then powering on the unit;
continue to press the encoder until the unit has completed its boot-up sequence.