User Guide

recording drums, explosive sound effects, etc. We suggest that you only change these jumper settings if you
are actually experiencing overload conditions.
Remove the top cover as described above. Now look to the rear of the unit, adjacent to the universal input
connectors (see illustration below).
You will see four pairs of jumpers, two pairs for each channel. You can configure each channel indepen-
dently if you wish, but be sure to move all four jumpers for a channel. The jumpers each plug on to three-pin
connectors. Each jumper connects the frontmost and center pin for high gain (factory default) or the center
and rearmost pin for reduced gain. To reposition a jumper, grasp it with a pair of tweezers and pull it directly
upwards to remove it, then replace it over the desired pins.
Be sure that all four jumpers for a given channel are set the same way (all to the front or all to the
rear). Any other jumper positions will produce undefined results.
Mini•Me User’s Guide
Page 24