User's Manual

16
Step 8: Install mounting bracket.
- Align the mounting bracket with the holes and use
the 4 long screws (provided) to screw into the wall or
wall anchors. Make sure the existing doorbell wires
are accessible by pulling through the large hole in
the mounting bracket.
Step 9: Connect the wires.
- Use the included wire connectors to connect to the
doorbell terminal screws on the back of the Knok.
Connect the other end of the wires to the two orange
connectors – one wire each into the connectors.
Connect your existing doorbell wires into the other
side of each orange connector.
Step 10: Push connectors and wiring back into the wall.
Step 11: Remove the color case from the Knok and
secure the Knok onto the mounting bracket.