Use and Care Manual

Inspection:
• Always inspect your tiles before they are installed, as installation of material constitutes acceptance.
• Any questions as to acceptability must be resolved before installation. Mir Mosaic is in no way responsible
for the installation of our tiles or thereafter. The responsibility for correct installation rests with the end
user.
Installation:
• To prolong the life and beauty of your installation, it is best to secure a licensed installer familiar with the
industry standards established in the NTCA, ASTM, M.I.A. and ANSI handbooks for tile and trade
installation.
• Due to the natural character of stone products, it is very important that the proper installation and methods
are used according to the relevant industry standards. For specific questions or accepted industry
standards, refer to the Marble Institute of America (www.marble-institute.com).
• Natural stone may vary in absorption. It is recommended to pre-seal stones prior to installation. This will
help prevent setting materials and grouts from staining the surface of the stone. Penetrating type sealers
that leave the material looking natural are recommended for this purpose. Suggested sealer brands include
but are not limited to: Dupont™ Stonetech® Professional Sealer and Aqua Mix. Please refer to sealers
Manufacturer instructions prior to sealing. Test in a small area before sealing entire surface to ensure
suitability. Contact your purchase location for additional information on these types of sealers.
• We recommend installing stones over a clean, sound, and flat concrete or mortar substrate. The surface
should be free of contaminates or any condition that could compromise the bond of the tile. Always layout
your material prior to installation to ensure the appearance meets desired results.
• Use a high quality, well maintained wet saw with a diamond blade designed for cutting stone materials.
Using a poorly maintained tile saw or a blade will cause the tile to chip during cutting. Always cut tile
very slowly to avoid chipping.
• Grout joints should be packed full and free of all voids and pits. Excess grout should be cleaned from the
surface as the work progresses, while grout is fresh and before it hardens. Prior to grouting, test in a small
area to make sure that the right color grout is chosen and that the surface does not scratch during grouting.
Care and Maintenance:
Stone is a natural product and care should be taken to maintain its lasting beauty. To maximize the life of your
mosaic and retain its artistic integrity, please consider the following:
• Use only a mild, pH-neutral detergent cleaner and damp sponge or rag to clean your mosaic.
• Do not use acid, alkaline, and solvent-based cleaners. They can damage and/or discolor the tiles and the
grout.
• Do not allow soap, bleach or other cleaning solutions set on the surface.
• Do not wax any part of your mosaic.
• Do not let stains sit on your mosaic’s surface for extended periods. Clean promptly.