User`s manual

User Manual version 2305
APOLLO 120/150 IV
7-109
7.4.5. Integrated Peripherals
If the INTEGRATED PERIPHERALS option is selected from
the main menu, the screen below will appear. The following
sample screen consists of the default values for PC 710.
Phoenix - Award BIOS Setup Utility
Advanced BIOS Features
On-Chip Primary PCI IDE (Enabled)
IDE Primary Master PIO (Auto)
IDE Primary Slave PIO (Auto)
IDE Primary Master UDMA (Auto)
IDE Primary Slave UDMA (Auto)
On-Chip Secondary PCI IDE (Enabled)
IDE Secondary Master PIO (Auto)
IDE Secondary Slave PIO (Auto)
IDE Secondary Master UDMA (Auto)
IDE Secondary Slave UDMA (Auto)
USB Controller (Enabled)
USB 2.0 Controller (Enabled)
USB Keyboard Support (Disabled)
AC97 Audio (Auto)
Flash ROM Write (Enable)
Onboard LAN Function (Enable)
Init. Display First (Onboard/AGP)
IDE HDD Block Mode (Enable)
Power On Function (Button Only)
KB Power On Password (Enter)
Hot Key Power On (Ctrl-F1)
Onboard FDC Controller (Enable)
Onboard Serial Port 1 (3F8)
Serial Port 1 Use IRQ (IRQ4)
Onboard Serial Port 2 (2F8)
Serial Port 2 Use IRQ (IRQ3)
UART Mode Select (Normal)
RxD, TxD Active (Hi, Lo)
IR Transmission Delay (Enabled)
UR2 Duplex Mode (Half)
Use IR Pins (IR-Rx2Tx2)
Onboard Parallel Port 3 (378)
Serial Port 3 Use IRQ (IRQ7)
Onboard Serial Port 4 (2E8)
Serial Port 4 Use IRQ (IRQ 11)
Onboard Parallel Port 1 (378)
Parallel Port 1 Use IRQ (IRQ7)
Parallel Port 1 Mode (SPP)
LPT1 EPP Mode Select (EPP1.7)
LPT1 ECP Mode Use DMA (3)
PWRON After PWR-Fail (OFF)
DIO Port Address (200)
Item Help
Menu Level