Installation Guide

10 www.apolloow.com Customer Service: 1.888.229.2874
PEX ONE HAND PINCH CLAMP TOOL
HOW TO USE
One Hand Pinch Clamp Fastening Tool
1. Cut PEX tubing square, leaving a clean, even
edge. Remove any burrs.
2. Slip PEX pinch clamp over tubing and insert
tting. Place pinch clamp 1/8" below edge
of tubing.
3. Place pinch clamp nub between tool jaws
and ratchet the clamp (approximately seven
times) until the LEDlight comes on. This will
assure that the pinch clamp is fully engaged.
4. To release the Pinch Tool, rotate the release
lever on the side. It is very important to
complete the pinch process before releasing
the tool.
For use with Apollo
®
, Watts
®
, Murray
®
, and Oetiker
®
PEX pinch clamps.
Do not use with Zurn
®
Qickclamp
. Do not use the fastening tool to remove pinch
clamps.
The LED light may not turn on after more than 7 ratchets when installing some 1 in.
pinch clamps. Don’t overclamp! Check with specication of pinch clamp manufacturer.
LED Light On
Release Lever
69PTBJ0010C
Apollo® PEX Pinch Clamps
PXPC3810PK 3/8" 10 Pack
PXPC1210PK 1/2" 10 Pack
PXPC1225PK 1/2" 25 Pack
PXPC12100PK 1/2" 100 Pack
PXPC3410PK 3/4" 10 Pack
PXPC3425PK 3/4" 25 Pack
PXPC34100PK 3/4" 100 Pack
PXPC15PK 1" 5 Pack
PXPC110PK 1" 10 Pack
LED Battery (Can be purchased at any local retailer)
CR927 Lithium Cell (3V) 1