User`s manual

6. Viewer
Barco – Apollo – DOC-3197-2 – user's manual – Revision 08 – November 2006
_________________________________________________
169/402
Parameter Values Description
tion , 100 means max reduction
Frameratereduction-
mode
[0|1|2] specifies if to use the default frame reate reduction (mode:0)
which is also the default setting, or if to use no reduction (mode:
1), or if to specify a variable frame rate reduction (mode:2)
Hue [1..100] Hue (in percent)
LastFrameOnSignalLoss [0|1],
disable, enable signal loss detection (default is 0, disabled) This
option only makes sense for streaming video card types. If dis-
abled the insertion will get blue during signal loss. If enabled
the insertion will still hold the last frame during signal loss.
Port [1..9] Port of the channel on the input card
RemotingSetting-
sEnabled
[0|1] disable | enable remoting capabilities (default is 0: disabled)
RemotingSettingsLogi-
calHostname
[]
string specifying a configured Pro- or VNC- source out of the
viewer sources
rgbBlue [0..100] Blue fraction of the RGB signal
(in percent)
rgbGreen [0..100] Green fraction of the RGB signal
(in percent)
RGBPresetName [] name of the preset to load
RgbProfileName [] Name of the profile for the RGB source
rgbRed [0..100] Red fraction of the RGB signal
(in percent)
rgbReduction [0..100] Factor of the dyn. reduction rate
Saturation [1..100] Saturation (in percent)
SclPixelFormat [], name of the pixel format to choose manually (RGB 8:8:8, RGB
5:6:5, YUV 4:2:2), default is automatic mode
SclPixelFormatAuto-
matic
[0|1], disable / enable automatic pixel format mode (default is 1,
automatic mode)
SclSharpness [0..15], number to change the scale sharpness (0 is default)
Sharpness [1..100] Focus/sharpness (in percent)
SrcProfileName [] Name of the profile for the video source
SVBAddress [] string to change the IP address of a streaming video board
SVBCodecName [] string to change the codec for streaming video boards (mpeg2,
mpeg4, visiowave, ...)
SVBGateway [] string to change the gateway used by a streaming video board
SVBNetmask [] string to change the netmask used by a streaming video board
SVSAddress
[] 'unicast', 'broadcast', real IP-Address if multicast
SVSEncAddress
[] network: IP-Address of the encoder
SVSEncPort
[] network: Port of the encoder listening for commands
SVSEncProtocolId
[0|1] encoder type: IP-Protocol index 0 (default): udp, 1: tcp*
SVSEncStartCmd
[]
encoder type: optional command to send to encoder to start
streaming ("" is default)