Installation manual

Specifications
Apollo SL30 Installation Manual
39
NAV RECEIVER PERFORMANCE
VOR
TSO compliance ......................................TSO-C40c (DO-196)
Applicable documents..............................RTCA DO-196
Operational class......................................N/A
Accuracy category...................................B {-46
o
C to + 55
o
C }
Frequency range.......................................108.00 to 117.95 MHz in 50 kHz increments
Frequency tolerance.................................0.0008%
Cross modulation products.......................At least 60 dB down
Receiver sensitivity ..................................108 MHz –115 dBm typical
117 MHz –117 dBm typical
Course accuracy.......................................RTCA DO-196 two sigma limit: 3
o
SL30 performance: less than 0.5
o
typical
Audio output ...........................................With a 1 kHz tone 30% modulation at least 100 mW
output into 500 ohm loads
Ident/voice...............................................With 100 mV input, 30% modulation at 1020 Hz,
the ident/voice tone ratio shall not be less than15 dB
Audio response........................................Less than 6 dB variation from 350 Hz to 2500 Hz
LOCALIZER
TSO compliance ......................................TSO-C36e (DO-195)
Applicable documents..............................RTCA DO-195
Operational class......................................A {manual landing systems}
Accuracy category...................................B {-46
o
C to + 55
o
C }
Frequency range.......................................108.00 to 111.95 MHz
Frequency tolerance.................................0.0008%
Cross modulation products.......................At least 60 dB down
Receiver sensitivity ..................................-110 dBm typical
Centering error ........................................RTCA DO-195 two sigma limit: 6.6% of full scale
SL30 performance: less than 1.0% typical
Audio output ...........................................With a 1 kHz tone 30% modulation at least 100 mW
output into 500 ohm loads
Ident/voice...............................................With 100 mV input, 30% modulation at 1020 Hz,
the ident/voice tone ratio shall not be less than15 dB
Audio response........................................Less than 6 dB variation from 350 Hz to 2500 Hz