Owner's Manual

Functions
The
use
of
automatic recording function.
Start the car engine and the
Smart
Vision will automatically start recording
(automatic recording function should be set to on). Turn
off
the car engine
and the
Smart
Vision will automatically turn off. The recorded image
segmentation is preserved on the TF card. When the TF card storage
is
full, the recorder will overwrite the earlier recorded image.
[Note]
1.
A recording time can be set in the menu in the range
of
1,
3, 5 minutes
or
off.
2. Files are stored by A (front DVR) and B (rear camera)
in
folders
"DCIMA"
and "DCIMB"
and each folder has subfolders for locked,
normal (video) and photos.
Manual
recording function
Press the power button for 3 seconds and the SmartVision will start.
To
tum
off
the
Smart
Vision press the power button for 3 seconds.
Using
the camera function
Once
the SmartVision
is
powered on, short press the camera button
(mode) to go into the camera mode. This will display an icon (camera)
in
the top left comer
of
the screen.
To
take pictures press the display button.
To
change back to the video
mode short press the camera button 2 times.
Motion detection function
In the standby mode, go into the menu/setting mode by long pressing the
mode button. Change auto detect to "on"
and when the lens picks up the
movement
of
objects, the
Smart
Vision enters the video state and when the
lens senses no movement for 5 seconds it will stop recording. There will
be an icon (person in motion) in the upper left comer when
in
motion
detection mode.
To
exit
or
enter into the motion detection mode, long time
press the up button.
[Note]
This setting is not saved and the next boot up will restore to video mode.
3