Owner's Manual

Installation instructions for
your
Smart
Vision: (App-Tronics· recommends
installation by a professional service. Go to app-tronics.com and search dealer
locator.) Call1-888-587-4111 for assistance.
Mirror
installation:
1.
Each Smart
Vision
comes with a universal mounting bracket that fits most cars.
If
you ordered a vehicle specific mount the same installation guidelines may not
apply. (Refer to vehicles manual or consult your dealer for more information).
2. Install the mount that came with your SmartVision using the 4 provided
screws, be sure to tighten firmly but do not over tighten.
3. Remove the factory mirror and install the SmartVision on the existing anchor
attached to the windshield.
If
choosing to use our universal mount with provided
anchor you will need a windshield rear view mirror repair kit. (Not
Provided)
4. Next fmd your power source to be used for installation. Each SmartVision
needs both constant and accessory power as well as ground. Each
main-·wire
harness has
these wires marked clearly. Guide the main harness down the A
or
B
pillar to this location. You can gently remove the weather stripping and tuck into
place then use your fmgers to push harness inside headliner to the mirrors
location.
A.
Using a volt meter locate you constant power source, tap the
Red
wire (12
Volt
Positive) into this source. Be sure that this constant power source does not
"go
to
sleep"
after
15
minutes.
B.
Use the same process to find an accessory power source (Power
only on
while car is running or in accessory keyed position). The Blue wire will need to
be tapped into this source.
C. The Black wire is your ground, locate a strong solid grounding source.
Attach the Black wire to this location.
Rear
camera
installation:(App-Tronics recommends installation by a
professional service. Go to app-tronics.com and search dealer locator.) Call
1-888-587-4111 for assistance.
1.
Guide the rear camera harness from the end
of
the main harness to the back
of
the vehicle removing trim pieces as needed. Note: Route the correct end to the
back
of
the vehicle. The end with the Black and
Red
wire go to the back end to
tie into reverse bulb.
6