Owner's Manual

2. The
Green
wire at the end
of
main harness needs to be tied into the vehicles
reverse relay,
if
it cannot be located you can tie the
Green
wire to the camera
harnesses Red wire coming out
of
the RCA feed. For faster trigger time, tying
into the vehicles reverse relay is the suggested method.
You
will see a Red wire
coming from each end
of
the camera harness.
3. Locate the reversing bulbs power source, the rear cameras harness will have
a Red and Black
wire that will need to be tapped into the reversing bulbs
power and ground. This will allow the rear camera to turn on when car is put
into reverse.
You
will need to tie the secondary Red wire coming out
of
the
RCA line to the reverse bulb power source as well.
4. Find a suitable location to attach the rear camera to the vehicle. Depending
on vehicle, cameras may vary.
Use
the provided double sided tape and screws
provided for installation.
(Some trim pieces will need to be removed and then
reinstalled for proper installation).
5. The Rear camera installation above allows for
the rear camera to only record
while in reverse.
To
record rear camera
at
all times please follow the diagram
below.
Note:Some
Smart
Vision's come with
rear
cameras
that
do not have
RCA
feeds on both ends.
If
wanting
to
record
rear
image
at
all times you
must
have
this type
of
rear
camera
harness.
7