Owner's Manual
Table Of Contents
Attach your ( ) to the vehicle specific reversing signal
or
insurance box reversing power fuse relay. This requires professional installation
to locate the manufacture location. If you cannot find this location you may tie
the ( ) power to the red wire coming from rear camera wire
feed. App-Tronics highly recommends using the front relay
if
possible.
This connection will power your DVR screen to
turn
on
rear camera when
put
into reverse same
as
if
you were to tie into the reversing relay.
Yet
for best re-
sponse time it's better to install into the reverse signal relay inside the front cab.
Please note some vehicles reversing bulb voltage coming from the front relay is
not
always sufficient to
run
a rear camera.
As
the power
is
distributed to
other
bulbs. If you find such an issue tying into the reverse relay upfront with the
( ) should eliminate this issue.
Or
you may use your own
relay to find a stronger current, for instants
on
BMW's.
You
can attach your own
relay
and
go right to the main battery located in trunk.
There are very
few
cars that have this issue. Just be sure camera
is
receiving 12
volts
or
higher.
Next
run
the rear camera wire feed to back
of
vehicle along the floor board
trim
then
under
rear seat. Mount your camera in desired location.
To
do this properly
some panels may need to be removed
in
trunk
or
lift gate.