User's Manual

16
APPI-Com V3.4 – Copy prohibited www.appi-technology.com
APPI-Com: rubber cover (mandatory for the ATEX version)
APPI-Com radio can be inserted into the protective cover after installing the protective glass: with external
antennas, first insert the antenna, then insert the radio the rubber. This cover is particularly effective against
dirt, shock and scratches and the shell is equipped with a belt clip but can also be used with the neck strap.
NOTE: APPI-Com module must be used with the provided Clip or Rubber cover (eventually inside the arm
band or harness), allowing a minimum distance of 5 mm (clip/rubber cover/armband/harness + garment
thickness) with the body (measurement conditions of the SAR "Specific Absorption Rate ").
Product’s label / recommendations (FCC-IC Model for USA/Canada)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
NOTE: The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance.
Such modifications could void the user’s authority to operate the equipment
ATEX version: the device MUST exclusively be used with its rubber cover and its antistatic plastic
screen. It is Prohibited to remove the rubber cover in a zone 2 or 22.
NOTE ON THE POTENTIAL DANGER OF ELECTROSTATIC CHARGES of the CASE
In use, a charge may appear by rubbing on clothing. The APPI-Com case must be worn underneath or
in ATEX clothing as ATEX DIR 89/686/EEC
Rubber covers are available in various
colors (red, gray or orange) and can be
cleaned with a damp cloth.
ATEX Version (Atmosphere EXplosive): model BS-APC2-Ax
The ATEX version of the device is different from the standard one: one can clearly identify it with it special
front side marked with the ATEX symbol
ATEX certification class :
CE II 3G/D Eex is T6 IP67
ATEX certification: usage limitations & compliance with ATEX regulation
1. Usage temperature limits: -10°C à +60°C
2. Authorized for use in a zone 2 (GAS) and zone 22 (DUST)
3. Authorized for use with the provided ATEX Audio accessory, exclusively.
4. Authorized for use with the provided rubber cover, exclusively.
5. Authorized for use with the provided internal or pre-fitted external antenna, exclusively.
6. Prohibited to connect or disconnect device peripherals in a zone 2 or 22.
7. Prohibited to remove the pre-fitted external antenna in a zone 2 or 22.
8. Prohibited to remove the rubber cover in a zone 2 or 22.
9. Prohibited to use the device in a zone 1 or 21 and a zone 0 or 20, or if the plastic case is defective.
10. Prohibited to charge the battery in a zone 0, 1 or 2 and zone 20, 21 or 22.