User's Manual

APPI-Com V3.4 – Copy prohibited www.appi-technology.com

Configuration software

An APPI-Com module can only communicate with modules having the same kit ID. In factory configuration,

the Radios are configured with the same kit number: there is therefore no need to configure.

Thereafter, the user may wish to change the configuration of the modules in the following cases:

• Replace a radio in a kit, Create new kits (example: 3 kits of 2 modules from 2 kits of 3, etc.)

• Enable / disable the "Secret" mode, enable or disable the "Talk" and / or "Listen" modes, etc.

Installing the PC configuration software

 The Software is provided on a USB key, with an

Autorun.exe program:

 Click on the Install button to launch the APPI-Com

Configuration installation software.

 When the software is installed, an

icon will appear on the desktop to

launch the software:

Configuring an APPI Kit for 3 – Tutorial

The purpose of the example described below is to create a kit consisting of 3 Radios:

1. The software proposes to create a Kit or

an advanced configuration.

2. After choosing “2 or 3 modules”, the

software requests to connect the

modules and indicates the number of

detected modules.

3. Connect only the 3 Radios of the new kit,

using the provided USB cables, and

switch them on.

NOTE: detection could take more than a

minute.

NOTE: The Radios will switch to USB Mode, if not, change the COM/USB mode to USB