User's Manual

28
APPI-Com V3.4 – Copy prohibited www.appi-technology.com
Usage recommendations and marking
Safety recommendations
It is recommended to take the following safety precautions when using this device:
• Water and moisture – Modules are IP66 (water jets) or IP67 Certified (1m immersion, 30mn) for the ATEX and
Defense version. If exposed to more severe conditions (diving, plunge, etc.) turn immediately the power off and
return the unit to the service department for a control.
• Battery - Do not try to change the battery. Contact the manufacturer or dealer to replace the battery.
• Antenna - Never use the modules with external antenna without the antenna properly tightened: the radio range will
be considerably decreased, and the water-dust sealed protection is longer assured.
Note: in ATEX or FCC/IC version, the antenna is pre-fitted. Trying to remove it may damage the product.
• Risks - Avoid violent shocks to the modules and prevent scratches to the screen.
• Charging – the charging/configuration cable with an USB plug is to be used with an appropriate USB power charger
(Wall/Car…) delivering a clean 600mA (minimal)/5VDC (maximal).
Do NOT charge in Temperatures >45°C.
Marking: the information can be found on the product’s label at the back or lower side of the product, eventually
under the rubber cover. Example:
Contains a Battery. No not remove/change
the battery by yourself.
Do not put in fire, do not throw away by
crushing: Risk of Explosion
FCC (USA). This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation.
NOTE: The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for
compliance. Such modifications could void the user’s authority to operate the equipment
IC (CANADA): This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and
Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions: (1) This
device may not cause interference, and (2) This device must accept any interference, including interference that may
cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes : 1) L’appareil ne doit pas produire de brouillage, et 2) L’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Maintenance advices
To maximize comfort and duration of use of this device:
• Cleaning - Use a soft damp cloth. Do not use liquid cleaners, benzene, solvents or aerosols.
• Repairs - Do not attempt to repair or modify the circuitry of the device: contact your dealer. Use only parts and accessories
recommended by the manufacturer: use with any other spare part or accessory and opening the module causes the cancellation of
the guarantee.
Disclaimer:
Please note that the French and the English versions of this manual are the only ones certified by the
manufacturer APPI-Technology. Any other variant provided by an authorized distributor should not be used
as a reference. This disclaimer is not to be translated in any other language.
A copy of the certification or declarations of Conformity is available on request at [e-mail]
APPI Products are designed and manufactured in France at:
- APPI-Technology SAS – 443 Avenue Jean Prouvé – 30900 Nimes – France
- [e-mail] – Tel.: [phone] - www.appi-technology.com
Document Part Number: BS_UMAN_342F Version: April 2022