Install Instructions

Step 4: Verify that both o-rings are

fully seated in their grooves. Apply

vacuum grease and reinstall Filter

Screen and Debris Catch Tube.

Step 3: Install Upper (black) o-ring,

working from back to front until o-ring

is fully seated in groove.

Step 2: Install Lower (red) o-ring,

working from back to front until o-ring

is fully seated in groove.

Continued

KTT840-R Tez8 Exterior Maintenance Kit

www.AppionTools.com

Step 1: Carefully remove old o-rings.

DO NOT use sharp tools, this can

damage the o-ring grooves.

O-Ring & Seal Sizing Guide

KTT840-R

Tez8 Exterior Maintenance Kit

2800 South Tejon Street

Englewood, CO 80110

Support@AppionTools.com

Phone: (303) 937-1580

PAGE 1
KTT840-R TM 2800 South Tejon Street Englewood, CO 80110 Tez8 Exterior Maintenance Kit Phone: (303) 937-1580 Support@AppionTools.com O-Ring & Seal Sizing Guide Step 1: Carefully remove old o-rings. DO NOT use sharp tools, this can damage the o-ring grooves. A Step 2: Install Lower (red) o-ring, working from back to front until o-ring is fully seated in groove. A Step 3: Install Upper (black) o-ring, working from back to front until o-ring is fully seated in groove. B B C C www.AppionTools.
PAGE 2
E Step 2: Install the new TEZOM secondary seal(E) Push until flush and level with the exhaust chamber. Step 4: Using needle nose pliers to grab only the guide(making sure not to damage the sealing surface) and press until the guides locking tabs fully engage with the slot. Repeat until all 3 guide have been installed. D Step 1: Turn the TEZ8 upside down, grab the TEZOM seal and guide with a pair of needle nose pliers. Pull the guide out of its slot. Repeat until all 3 guides have been removed.