User's Guide

which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment to an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/
TV technician for help.
Important: Changes or modifications to this
product not authorized by Apple could void
the electromagnetic compatibility (EMC)
and wireless compliance and negate your
authority to operate the product. This product
has demonstrated EMC compliance under
conditions that included the use of compliant
peripheral devices and shielded cables
between system components. It is important
that you use compliant peripheral devices and
shielded cables between system components
to reduce the possibility of causing
interference to radios, televisions, and other
electronic devices. This product was tested
for EMC compliance under conditions that
included the use of Apple peripheral devices.
Responsible party (contact for FCC
matters only):
Apple Inc. Corporate Compliance
1 Infinite Loop, MS 91-1EMC
Cupertino, CA 95014
Class 1 Laser Information
This device is classified as a Class 1 Laser
product per IEC60825-12007 and IEC60825-
12014. This device complies with 21 CFR
1040.10 and 1040.11 except for deviations
pursuant to Laser Notice 50, dated June 24,
2007. This device contains lasers that could be
damaged during repair or disassembly, which
could result in hazardous exposure to infrared
laser emissions that are not visible. This
equipment should be serviced by Apple or an
authorized service provider.
Canadian Compliance Statement
This device complies with Industry Canada
license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired
operation of the device.
Cet appareil est conforme aux normes CNR
exemptes de licence d’Industrie Canada.
Le fonctionnement est soumis aux deux
conditions suivantes : (1) cet appareil ne
doit pas provoquer d’interférences et (2) cet
appareil doit accepter toute interférence, y
compris celles susceptibles de provoquer un
fonctionnement non souhaité de l’appareil.
Bluetooth Industry Canada Statement
This Class B device meets all requirements of
the Canadian interference-causing equipment
regulations.