1.0
Table Of Contents
- Color User Manual
- Contents
- Color Documentation and Resources
- Color Correction Basics
- Color Correction Workflows
- Using the Color Interface
- Importing and Managing Projects and Media
- Creating and Opening Projects
- Saving Projects and Archives
- Moving Projects Between FinalCutPro and Color
- Reconforming Projects
- Importing EDLs
- Exporting EDLs
- Relinking QuickTime Media
- Importing Media Directly into The Timeline
- Compatible Media Formats
- Converting Cineon and DPX Image Sequences to QuickTime
- Importing Color Corrections
- Exporting JPEG Images
- Setup
- Monitoring
- Timeline Playback, Navigation, and Editing
- Video Scopes
- Primary In
- Secondaries
- Color FX
- Primary Out
- Managing Corrections and Grades
- The Difference Between Corrections and Grades
- Saving and Using Corrections and Grades
- Applying Saved Corrections and Grades to Shots
- Managing Grades in the Timeline
- Using the “Copy to” Buttons in the Primary Rooms
- Using the Copy Grade and Paste Grade Memory Banks
- Setting a Beauty Grade in the Timeline
- Disabling All Grades
- Managing Grades in the Shots Browser
- Using the Primary, Secondary, and Color FX Rooms Together to Manage Each Shot’s Corrections
- Keyframing
- Geometry
- Still Store
- Render Queue
- Calibrating Your Monitor
- Keyboard Shortcuts
- Setting Up a Control Surface
- Index
Chapter 9 Primary In 199
This operation certainly neutralizes the red in the shadows; unfortunately, because this
one control point is influencing the entire curve, this correction also removes much of
the original red from the midtones as well.
∏ Tip: If you’re wondering where you should place control points on a curve to make an
alteration to a specific area of the image, you can use the height of the corresponding
graphs in the Waveform monitor set to either Parade (if you’re adjusting color) or Luma
(if you’re adjusting the Luma curve). For example, if you want to adjust the highlights of
the image, you’ll probably need to place a control point in the curve at approximately
the same height at which the highlights appear in the waveform graph.
2 Add another control point near the top of the red curve, and drag it up until some red
“fill” reappears on the side of the woman’s face.
This adds the red back to the woman’s face, but now you’ve added red to the
highlights of the key light source, as well.