X

666Final Cut Pro User Guide
4. Drag the middle control point to adjust any of the following (depending on which curve
you’re using in the Color inspector):
• Hue vs Hue: Change the hue in the selection. Drag the control point up or down to
rotate through the various hues around the perimeter of the color wheel.
Note: If you use the Hue vs Hue curve to change the hue and then use the
eyedropper in any other curve in the same instance of the Hue/Saturation Curves
color correction effect, the eyedropper selects the original hue—not the altered hue.
To select the original hue, adjust the control points without using the eyedropper, or
add a second instance of the Hue/Saturation Curves color correction effect.
• Hue vs Sat: Adjust the saturation of the selected color. Drag the middle control point
up to increase the saturation, or down to decrease the saturation. Add or adjust
control points as needed.
In the example below, the HvS button was clicked in the Single Curves view, and the
eyedropper was used to select the hue of the wall in the image.