User Guide

Screen tilts to the left or the right even after a manual adjustment.
Note: It is normal for the screen on an iMac (Flat Panel) to have a small amount of horizontal play.
However, the screen should be able to be adjusted so that it will stay in a level horizontal position.
1. Remove ten screws connecting the back cover to the flat panel LCD display (refer to the Take Apart
chapter, display topic).
2. Disconnect the panel cables to gain access the three screws on the metal cable retainer shown below.
Remove the screws and lift the cable retainer off the panel shield.
3. Loosen the four screws (shown below) that hold the panel shield to the neck assembly, and tilt the
screen the opposite direction of the tilt.
4. While holding the display bezel in this position, tighten the same four screws that hold the panel shield
to the neck assembly.
5. Replace the panel and check that the display is now horizontally level.
20 - iMac (Flat Panel) Troubleshooting
Display Symptom Charts