User`s manual

Don’t attempt to disassemble the printer.
Don’t place anything on top of the printer.
___________________________________________________________
Maintenance
The toner cartridge holds the toner powder the printer’s "ink" that forms the printed images.
When the cartridge needs replacing, it’s also time for routine maintenance.
Each cartridge should yield about four thousand pages. If you print a lot of graphic designs, you
may need to change cartridges more often. If your pages start to look too light, or if you see thin
vertical white lines in dark images, it’s time to change the cartridge.
The Low Toner Level light glows orange when the cartridge needs replacing or when the toner
powder needs to be redistributed.
___________________________________________________________
Important-If the light comes on in the middle of a printing job, and the output is still
satisfactory, continue printing if you wish. You won’t harm the printer by doing so.
___________________________________________________________
When the light comes on, take the cartridge out, rock it gently back and forth a few times to
redistribute the toner, and reinsert it. If the light goes out, continue to use the cartridge for
the time being. If the light stays on, change the cartridge and perform the routine maintenance
procedures described in the following sections.
___________________________________________________________
Installing a new toner cartridge
1. Remove and discard the used cartridge. Pull out the cartridge. Be careful to keep it
horizontal so that no remaining toner powder spills into the printer.
2. Install the new cartridge. You install the new cartridge exactly as you installed the one sup-
plied with the printer. For details read the guide supplied with the cartridge.
___________________________________________________________
Whenever you install a new toner cartridge, you should also clean the interior of the
LaserWriter II and replace the cleaning pad. A replacement pad is supplied with each cartridge.
___________________________________________________________
Warning-Be very careful during all cleaning operations not to break any of the wires inside the
printer.
___________________________________________________________
1. Open the green felt cover that protects the fixing rollers.
___________________________________________________________
Warning-If you have not allowed the LaserWriter II adequate time to cool, the felt cover may be
hot, and the fixing rollers will be very hot.
___________________________________________________________
2. Remove and discard the used cleaning pad.
3. Unwrap the new cleaning pad.
Remove and put aside the cotton swab attached to the pad by a rubber band. You’ll use the swab
for cleaning the printer wires.