User`s manual

4. Use the end of the new pad to clean the fixing rollers.
Before you install the new pad, clean the fixing rollers by wiping them with the white felt tip at
the end of the pad.
5. Remove and discard the white felt tip from the end of the cleaning pad.
6. Insert the new cleaning pad into the fixing roller assembly. Then close the green cover.
7. Clean the discharging pins. Use the cleaning brush supplied with the printer to brush any
dust off the discharging pins. Store the brush in the printer when you’re finished.
8. Wipe the transfer corona wire clean. The transfer corona wire is the very thin wire in the
midsection of the LaserWriter II. Wipe it and the diagonal wires above it very gently with the
cotton swab supplied with the new cleaning pad.
___________________________________________________________
Warning-The transfer corona wire is fragile. Be careful not to break it when cleaning.
___________________________________________________________
9. Wipe the transfer guide clean. Use a clean, soft, slightly damp cloth to wipe off the transfer
guide. (It’s the metal plate behind the transfer corona wire)
10. Close the LaserWriter II and resume printing.
___________________________________________________________
Exterior cleaning
Unplug the power cord and then wipe the exterior of the printer with a clean, soft, damp cloth.
Use a mild soap or detergent if necessary, but never an ammonia-based cleaner. Be careful not
to get any liquid in the power cord port.
___________________________________________________________
Warning-Never use ammonia-based cleaners on or around the LaserWriter II.
___________________________________________________________
Troubleshooting
You’re not likely to have many problems with the LaserWriter II, as long as you follow the
routine maintenance procedures in this chapter. Changing the toner cartridge is usually all
that’s needed to keep print quality up to publication standards.
Most operating pitfalls can be traced back to software installation. To avoid these problems,
always use a startup disk that includes the LaserWriter II printer resource and the appropriate
fonts.
___________________________________________________________
The Chooser isn’t listed in the Apple menu
If the Chooser isn’t listed in the Apple menu, the System file on your startup disk is outdated. If
you want to use this disk as a startup disk, update it before proceeding. You can obtain the
current system software from your authorized Apple dealer.
___________________________________________________________
No LaserWriter icon appears in the Chooser
You may need to install the printer resource on the current startup disk.