User`s manual

___________________________________________________________
Removing jammed paper from the fixing rollers
___________________________________________________________
Correcting image problems
If the image is too light:
1. Check the Low Toner Level light.
2. Turn the print density dial one step counterclockwise (one number lower).
The print density dial is inside the printer, in the lower-left corner.
3. Check to see that the paper is of a recommended type.
If the image is too dark:
Turn the print density dial one step clockwise (one number higher).
If white or dark vertical or horizontal lines or stripes appear on the page:
1. Remove the toner cartridge and rock it to a 45-degree angle four or five times to
redistribute the toner. Be sure to hold the cartridge horizontally.
2. If this doesn’t work, install a new toner cartridge. Also install a new cleaning pad and clean
the transfer corona wire and transfer guide.
If stains appear on printer output:
1. Clean the transfer guide, transfer corona wire, and discharging pins exactly as you would if
you were installing a new toner cartridge.
Wipe the transfer corona wire very gently with a cotton swab. Wipe the transfer guide with a
soft, clean, damp cloth. Brush off the discharging pins with the cleaning brush stored in the
printer.
2. Clean the primary corona wire. Take out the toner cartridge and insert the cleaning brush
into the slot at the cartridge’s front. Work the brush gently back and forth to clean the wire.
__________________________________________________________________
Appendix A: The LaserWriter II Upgrades
__________________________________________________________________
The LaserWriter II Upgrades
To upgrade a LaserWriter IInt to a LaserWriter IIntx, simply have your authorized Apple
dealer install a LaserWriter IIntx controller board. The used LaserWriter IInt controller board
is your property. If you choose to store it, be sure to do so in a static-free bag, available
through your authorized Apple dealer.