Technical information

Depending on the amount of memory you have in the printer, you may need
to remove a SIMM in order to insert one that has more memory. For example,
if you have 20 MB of RAM in your printer and want to upgrade to 48 MB of
RAM, you must remove the 4 MB RAM SIMM and install a 32 MB RAM
SIMM.
1Hold the bag containing your SIMM and touch any metal part of the printer. Then open
the bag containing the SIMM.
This prevents any static electricity from discharging into the SIMM and
damaging it.
2Insert the SIMM into the connector at an angle, and gently press the SIMM down at a
horizontal angle until the retaining clips on each end of the connector snap and fasten
the SIMM in place.
Hold the SIMM vertically over the slot, aligning the connectors and notches
with the circuit board’s connector. One edge of the SIMM has a distinctive
notch that you can use to judge the orientation and alignment of the SIMM
with the connector. This notch, on the left edge of the SIMM, should be on
the left side as you install the SIMM.
Insert the card
straight in.
Gently angle
the card back.
Snap the card into
the retaining clips.
Notch
116
Chapter 5