User guide

586 Chapter 25 Mixing
To adjust the send destination of all selected channels:
m Click on any of the selected channel’s unused Send slots, and make your choice from
the list of Bus destinations (aux channels).
The corresponding Send slots of all selected channels will be routed to the chosen
destination.
To adjust the inserts of all selected channels:
m Click on any of the selected channel’s unused Insert slots, and make your choice from
the list.
The selected effect will be inserted into the corresponding Insert slot on all selected
channels.
To adjust the input and output routing of all selected channels:
m Click on any selected channel’s Input or Output slot, and make your choice from the
list.
All selected channels will be set to the chosen input or output.
To adjust the automation mode and group setting of all selected channels:
m Click any selected channel’s Automation mode or Group menu, and make your
selection from the list. All selected channels will be switched to the chosen setting.
Important: You can only perform the multi-channel (insert) Send and Insert options if
no active Send or Insert is in the same slot on any selected channel. In other words,
ensure that all selected channels have an unused Send 3, or Insert slot 4, for example,
before using this facility.
Adjusting Channel Strips in Record or Playback Mode
You can prevent the track selection from changing, when making an adjustment to a
channel. This can be done while Logic Express is in recording or playback mode,
allowing you to adjust a particular Mixer channel, even if a different track is being
recorded.
To prevent the track selection from changing when recording:
m Make sure the Mixer’s Options > Change Track in Record Mode setting is disabled.
To prevent the track selection from changing when playing back your project:
m Make sure the Mixer’s Options > Change Track in Playback Mode setting is disabled.