Setup guide

Chapter 8: Sequoia 25
Chapter 8: Sequoia
You can use Artist Series controllers with Sequoia (version 11.02 or higher) from Magix.
To setup and configure EUCON for Sequoia:
1 Open or create a new project.
2 Choose Options > System/Audio...
3 Under System Options, click Hardware Controller.
4 In the EUCON section, click to enable Activate EuCon.
5 Click Reset connection.
6 Click Apply.
7 Click OK.
8 Restart EuControl.
9 Power cycle all Artist Series controllers.
10 Launch Sequoia.
Always check with the manufacturer of your specific application for the most recent software, requirements, and instructions.
Sequoia Hardware Controller window