Setup guide

Chapter 12: Cubase 39
Chapter 12: Cubase
Steinberg’s EuCon adapter enables fully integrated control of all Cubase functions from Artist media controllers.
To enable Cubase to work with your Artist media controller, you must obtain an activation code:
1 Create a user account in the MySteinberg area of the Steinberg web site if you have not already done so. If you already have a
MySteinberg account and have already registered your version of Nuendo, continue with Step 2. To activate an account and reg-
ister Nuendo, follow the on-screen instructions which will be similar to the following:
• Check your email and activate your user account by clicking the link in the confirmation email.
• Log into your MySteinberg account, click on Product Registration, choose Register Product and select Product with Steinberg Key
or Soft-eLicenser. Follow the on-screen instructions to register Nuendo.
2 Log into your MySteinberg account if you have not already. Click on Activation & Reactivation, choose Euphonix Artist Series Eu-
Con Adapter and select Permanent Activation.
3 Enter your Artist media controller’s serial number. You will receive an email containing the activation code.
4 Launch the License Control Center (LCC) Software from the Applications folder, choose Wizards > License Download, enter your
activation code and follow the instructions.
For Cubase to communicate with the Artist media controllers, the EuCon device must be added in the Device Setup.
To add the EuCon adapter in Device Setup:
1 Open Cubase but do not open a project. If Cubase automatically opens a project, close it.
2 Choose Devices > Device Setup. Device Setup opens.
3 Click the + button (add) on the top-left. A pop-up list of devices appears with EuCon near the top of the list.
4 Select EuCon from the drop-down list.
The EuCon device is added, the control surface immediately updates, the faders and knobs display track functions, and the Eu-
Con Device Setup dialog appears (see “EuCon Device Setup” on page 40).
Cubase version 4.1.2 and higher is required. Always check with the manufacturer of your application for the most recent software,
requirements, and instructions.