Setup guide

EUCON Application Setup Guide46
3 Locate the application you want to control in the Finder. This is found in your Applications folder or in the program’s own
folder at the top level of the hard drive.
4 Drag the Application icon into the middle of the Preference pane and release the mouse button. Its name and location appears
in the Application and Path columns, respectively.
5 Click in the Protocol column and select Mackie Control.
6 Close the EUCON Preference pane and reboot your computer if prompted to do so.
The next steps configure your specific application to be controlled by Mackie Control. This differs for each application and in-
structions can be found in the application’s user manual. For your convenience, we’ve included instructions for several applica-
tions in the following sections.
When setting up an application to be controlled by Mackie Control, use the MIDI ports of the EuCon MIDI Driver that were spec-
ified in the EUCON Preference pane (such as 1–4).
More than one application can be controlled using Mackie Control by dragging multiple application icons into the EUCON Pref-
erence pane. Make sure each application has it’s own unique set of MIDI ports.
To access the Mackie Control Master fader:
 Press the ASSIGN key (lights) on any fader strip on any Artist media controller in the network.
EUCON preference pane with application selected and Mackie Control set
Always check with the manufacturer of your specific application for the most recent software, requirements, and instructions.