Setup guide

Appendix B: Pro Tools (HUI) 53
Create and Use Wheel Nudge
Scroll your Artist Series media controllers through the Pro Tools tracks in the session you wish to control with the Jog Wheel. This
is much like moving a chair into the proper position in front of a large console.
To create and use wheel nudge:
1 Open the Softkey editor.
2 Select a Softkey in the editor.
3 Press the Command button.
4 Add a EUCON command
5 Click the drop down list and select the WHEEL command.
6 Select the Artist Control Jog wheel in the top drop-down on the right hand side of the command editor.
7 Select Left Edit > Nudge in the bottom drop-down menu.
8 Save the command and exit.
9 Change the focus to Pro Tools.
10 Open the Mix window by pressing SHIFT + <NUDGE (mixer nudge).
11 Press the Nudge button you just created.
12 Use the Jog Wheel to nudge through tracks.
EQ Knob Set
The EQ knob set can control settings for four parametric EQ bands and access Q and band On and Off from the knobs.
To use the EQ knob set:
1 Enter the INSERTS knob set, create DigiRack EQ, and exit the INSERTS knob set.
2 Press the EQ button (Artist Mix) or EQ Knob Top (Artist Control).
3 Use the knobs to control EQ bands.
4 Press the ON button to toggle bands on/off (Artist Mix). Press the Touchscreen GAIN button to toggle bands on/off (Artist Con-
trol).
5 Press the Select button to toggle Freq/Q (Artist Mix). Press and hold the SHIFT key and press FREQ on the Touchscreen to toggle
Freq/Q (Artist Control).
6 Press the BACK key to exit.
DYN Knob Set
Quickly edit Digirack Dynamics plug-in parameters.
To use the DYN knob set:
1 Create a Digirack compressor and exit the INSERTS knob set.
2 Press DYN button (MC Mix) or DYN Knob Top (Artist Control).
3 Use knobs to control compressor parameters.
4 Press the BACK key to exit.