User Guide

Chapter 4 M-Audio iControl 113
Play/Stop
Press the Play button (denoted by a right arrow) to start playback from the current
playhead position—or to stop playback—if the project is currently playing.
Fast Forward Button
Quickly press the Fast Forward button (denoted by two right arrows) to move the
playhead forward by one bar. Hold down the Fast Forward button to continuously
move the playhead forward in one bar increments.
You can also press the Fast Forward and Cycle buttons simultaneously—to activate
Cycle mode, and set the right cycle border (right locator) to the current playhead
position.
Cycle Button
Press the Cycle button (denoted by two circular arrows) to activate Cycle mode. If Cycle
mode is active, pressing the Cycle button deactivates it.
You can activate Cycle mode—and set the left and right cycle locators, respectively—
by using the Rewind or Fast Forward and Cycle buttons together.
To set the left and right locators, and activate Cycle mode:
1 Use the Jog Wheel to move the playhead to the desired left locator position, then press
both the Cycle and Rewind buttons.
2 Do one of the following:
 Navigate to the desired right locator position with the Jog Wheel, then press the
Cycle and Fast Forward buttons simultaneously.
 Hold down the Cycle button, navigate to the position where you want to set the
right locator using the Jog Wheel, then release the Cycle button.
Master Fader
Moving the Master fader on the iControl sets the level of the Master fader in the
Logic Pro Mixer window. The Master fader changes the level of all output channels, but
does not affect the relative levels of channels that precede the Master fader in the
signal path. Move the fader left to decrease the master level, or to the right to increase
the master level.