User Guide

Chapter 1 Basic Control Surface Setup 25
 Input: Encoders adjust/select channel input source.
 Output: Encoders adjust/select channel output (main outs/auxes/surround).
 Automation: Encoders adjust/select channel automation mode.
 Group: Encoders adjust group membership of the track. Editing the parameter
allows you to set either “no group” or a single group. Enabling membership of
multiple groups is not possible (this can only be done directly in the Logic Pro
Mixer).
 Displayed Par.: Encoders adjust the automation parameter selected in the Arrange
window. This is especially useful if you set the control surface to Arrange View
mode, and your Arrange window shows multiple sub-tracks with various
parameters.
 Surround Parameter pop-up menu: Choose the surround parameter that the rotary
encoders will control. The choices are:
 Angle: Encoders adjust surround angle.
 Diversity: Encoders adjust surround diversity (direction).
 LFE: Encoders adjust LFE level.
 Spread: Encoders adjust the Spread parameter of Stereo to Surround channel
strips.
 X: Encoders adjust surround x position.
 Y: Encoders adjust surround y position.
 Center: Encoders adjust the Center channel level.
Note: The X and Y parameters are a different representation of the Angle and
Diversity parameters, and thus are independent from them. The X and Y parameters
support the use of surround joysticks.
 EQ Band: Sets the current EQ band, so that you can edit a particular Channel EQ or
Linear Phase EQ parameter for all tracks in the EQ Multi Channel View.
 EQ Parameter pop-up menu: Choose which parameter of the selected EQ band is
controlled by the encoders in EQ Multi Channel View. The choices are:
 Frequency: Encoders adjust the frequency of the selected band.
 Gain: Encoders adjust the gain of the selected band. For the Low Cut (band 1) and
High Cut (band 8) bands of the Channel and Linear Phase EQ, this parameter
controls the slope.
 Q: Encoders adjust the Q factor of the selected band.
 On/Off: Encoders bypass the selected EQ band.
 EQ Parameter Page: Sets the EQ parameter displayed in EQ Channel Strip view.
The Channel and Linear Phase EQs feature 8 bands per audio channel, with each
band offering four parameters. All of these parameters can be accessed with your
control surface.