10.6

69Logic Pro Effects
Channel parameters
• Input pop-up menu: Choose the input signal for the two stereo sides. Options include
Off, Left, Right, L + R, and L − R.
• Delay Time knob and field: Set the delay time in milliseconds or in note values when
synchronized with the project tempo. Notes (and dots) are displayed around the Delay
Time knob when synchronized with the project tempo. Click these buttons or dots (or
rotate the knob) to choose an exact synchronization value.
Note: Clicking note or dot values resets the Deviation parameter value. Choose a value
from the Note pop-up menu to retain the current Deviation value.
• Note pop-up menu: Set the grid resolution for the delay time when the Tempo Sync
button is active.
• Deviation field: Set the amount of deviation from the grid.
• : 2 and x 2 buttons: Halve or double the current delay time.
• Low/High Cut slider and field: Cut frequencies below the Low Cut value and above the
High Cut value from the effect signal.
• Feedback knob and field: Set the amount of feedback for the left and right delay signals.
• Feedback Phase button: Invert the phase of the corresponding channel feedback signal.
• Crossfeed Left to Right (Right to Left) knob and field: Transfer the feedback signal of
the left channel to the right channel, and vice versa.
• Crossfeed Phase button: Invert the phase of the crossfed feedback signals.
Global and Output Mix parameters
• Routing pop-up menu: Choose the internal signal routing. Options include Customized,
Straight, Crossfeed, 90/10, 10/90, Ping Pong L/R, Pan L/R, and Rotate L/R.
• Tempo Sync button: Synchronize delay repeats with the project tempo. Set note values
with the Note pop-up menu or Delay Time knob.
• Stereo Link button: Turn on to make corresponding parameter adjustments for both
channels. Adjusting one channel value adjusts the other. Relative values are maintained.
• Press Command to temporarily flip stereo linking, allowing you to adjust a control in
a linked fashion even when Stereo Link mode is not active.
• Command-drag a slider to adjust a single channel when in Stereo Link mode.
Note: Stereo Link mode can be automatically disabled when you choose a new routing
or setting. Reenable, if required.
• Output Mix sliders and fields: Independently control the level of the left and right
channel signals.