8
Table Of Contents
- Logic Pro 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Pro
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- EuCon Support of Euphonix MC and System 5-MC
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
122 Chapter 5 EuCon Support of Euphonix MC and System 5-MC
 EQ: Pressing the EQ Soft Key switches to EQ editing (see “EQ Knobset” on page 124).
The On key is lit when EQ plug-ins are enabled (not bypassed). Please note that this
only applies to Logic Pro plug-ins, not Audio Unit plug-ins. Pressing the On key
switches the bypass state of all EQ plug-ins.
 Sends: Pressing the Sends Soft Key switches to Send editing mode (see “Sends
Knobset” on page 125).
 Pan: Pressing the Pan Soft Key switches to Pan/Surround editing mode (see “Pan/
Surround Editing Knobset” on page 125).
 Groups: Pressing the Groups Soft Key switches to Group editing mode (see “Groups
Knobset” on page 126).
 Output: Pressing the Output Soft Key switches to Output parameter editing mode
(see “Output Knobset” on page 126).
Inserts (Configuration) Knobset
In this mode, the Soft Keys display the effect plug-ins inserted on the selected channel
strip.
If more than eight effect plug-ins are inserted, you can use the right Page key (of the
left Page key set) to display ensuing plug-ins.
To edit an effect plug-in:
1 Press the Soft Key (or respective knob top) that features the name of the plug-in you’d
like to edit.
This switches to Effect Plug-in Editing mode. The plug-in parameters are displayed in
the order shown in the Controls view of the effect.
2 Turn the respective knobs to change the desired values.
Pressing a knob top sets the controlled parameter to its default value. For parameters
with only two values, the On key is lit when the value is 1 (or on), and unlit when the
value is 0 (or off). Pressing the On key switches between the two values.
If the plug-in features more than eight parameters, use the left Page key set to navigate
between pages of parameters.
Pressing the Back key returns to the Inserts (Configuration) knobset.
To insert effect plug-ins:
1 In the Inserts (Configuration) Knobset mode, press both Page keys simultaneously.
This switches to Effect Insert mode. The Soft Keys display the first eight Insert slots of a
channel.
∏ Tip: If an Insert slot already contains an effect plug-in, the MC indicates this with a lit
On key.