8
Table Of Contents
- Logic Pro 8 Control Surfaces Support
- Contents
- Introduction
- Basic Control Surface Setup
- Customizing Controller Assignments
- Mackie Control
- Setting Up Your Mackie Control
- Using the Mackie Control With Logic Pro
- Display Zone
- Channel Strip Controls
- Master Fader
- Assignment Zone
- Fader Bank Zone
- Function Key Zone
- Global View Zone
- Modifier Buttons
- Automation Buttons
- Utilities Buttons
- Transport Zone
- Cursor Key Zone
- Jog/Scrub Wheel Zone
- Programmable User Modes
- Connecting Foot Switches
- Assignment Overview
- M-Audio iControl
- EuCon Support of Euphonix MC and System 5-MC
- CM Labs Motormix
- Frontier Design TranzPort
- JLCooper CS-32 MiniDesk
- JLCooper FaderMaster 4/100
- Korg microKONTROL and KONTROL49
- Mackie Baby HUI
- Mackie C4
- Mackie HUI
- Radikal Technologies SAC-2K
- Roland SI-24
- Tascam FW-1884
- Tascam US-2400
- Tascam US-428 and US-224
- Yamaha 01V96
- Yamaha 02R96
- Yamaha DM1000
- Yamaha DM2000
Chapter 3 Mackie Control 69
Alternate Mode Options
Holding down the PAN/SURROUND button displays a submenu on the LCD. The V-Pots
or Function keys allow you to make the following changes.
Notes on Surround X/Y Editing
X and Y have a value range of –1000 to +1000, but the resolution is not that high, as
surround positions are currently recorded as 7 bit data.
Note: The X and Y parameters are limited to a rectangular co-ordinate system. As such,
value pairs outside the surround circle are not possible. When trying to set a value
which would lead to an invalid position, the other co-ordinate is automatically adjusted
to a valid position. Example: Moving Y to +1000 will result in an X co-ordinate value
of 0.
When editing only one co-ordinate, the other co-ordinate of the most recently channel
strip is remembered. This helps you to create linear movements.
Control Action
V-Pot 1 or F1 Switches to Pan/Surround Mixer view and selects Angle.
V-Pot 2 or F2 Switches to Pan/Surround Mixer view and selects Diversity.
V-Pot 3 or F3 Switches to Pan/Surround Mixer view and selects LFE level.
V-Pot 4 or F4 Switches to Pan/Surround Mixer view and selects Spread.
V-Pot 5 —
V-Pot 6 or F5 Switches to Pan/Surround Channel view.
V-Pot 7 or F6 Switches to Surround Angle/Diversity Mixer view.
 The mode display shows “Ad” (Angle/Diversity).
 The upper LCD row shows channel strip names.
 The lower LCD row shows the surround angle currently assigned
to each channel strip.
 Turning a V-Pot changes the surround angle (or adjusts pan
position on non-surround channel strips).
 Pressing a V-Pot sets the surround angle to its default value.
 The faders edit surround diversity.
V-Pot 8 or F7 Switches to Surround X/Y Mixer view.
 The mode display shows “XY”.
 The upper LCD row shows channel strip names.
 The lower LCD row shows the surround X value currently
assigned to each channel strip.
 Turning a V-Pot changes the surround X value (or adjusts pan
position on non-surround channel strips).
 Pressing a V-Pot sets surround X to its default value.
 The faders edit surround Y.