X

Chapter 9 EXS24 mkII 178
Create a basic modulation routing
1 Choose the parameter you want to modulate from the Dest pop-up menu.
Click here to choose a
modulation source.
Click here to choose a
modulation destination.
2 Choose the parameter you want to use to modulate the destination from the Src pop-up menu.
3 Drag the intensity slider to set a xed modulation intensity.
Modulation intensity
slider
Bypass a modulation routing
m Click the Bypass (b/p) button at the top right of the modulation routing.
Bypass button
The Bypass button disables individual modulation routings without losing settings.
Use EXS24 mkII via sources
In a basic modulation routing consisting of a target and source, you can set a xed modulation
intensity by vertically dragging the arrowhead of the intensity slider to the right of the routing.
The slider value always denes a constant modulation intensity.
The intensity of the modulation can itself be modulated: via denes a further modulation source,
which is used to control the modulation intensity.
If you choose a value other than o (shown as “---”) from the via pop-up menu, the intensity
slider divides into two halves, each half with its own arrowhead.
•
The lower half of the slider denes the minimum modulation intensity, when the via
controller—the modulation wheel, for example—is set to its minimum value.
•
The upper half of the slider denes the maximum modulation intensity when the via
controller is set to its maximum value.
•
The area between the two slider halves denes the modulation range of the via controller.