X

Chapter 9 EXS24 mkII 180
Set the modulation intensity to zero
m Click the small 0 symbol that is halfway up the intensity slider control.
Invert the eect of the via modulation source
m Click the Invert (inv) button to invert the eect of the via modulation source.
EXS24 mkI modulation paths
Many of the hard-wired modulation paths that were available as sliders on the original EXS24
(mkI) are now integrated into the modulation router, which was not available in the original
EXS24. To reconstitute the modulation slider conguration of the mkI version, choose Recall
Default EXS24 mkI Settings from the Options pop-up menu. This loads the mkI modulation paths
into the modulation router, as follows:
•
Velocity to Sample Select
•
LFO 1 to Pitch via ModWheel (= Ctrl#1)
•
Velocity to Sample Start (inv)
•
LFO 2 to Filter Cuto via ModWheel
•
Velocity to Filter Cuto
•
Envelope 1 to Filter Cuto via Velocity
•
LFO 2 to Pan via ModWheel
You can alter the settings of these modulation paths—allowing you to use modulation sources
that were unavailable in EXS24 mkI.
Note: For technical reasons, the settings of the modulation router cannot be used in EXS24 mkI.